Linx PCB Flex
TE Connectivity / Linx Technologies | Part: ANT-8/9-FPC-UFL-100
No description available
Links & Resources
Some links may be affiliate links. Any commissions support Austin Mesh at no extra cost to you.
Specs
Brand
TE Connectivity / Linx Technologies
Part Number
ANT-8/9-FPC-UFL-100
Frequency
862-876 MHz, 902-928 MHz
Connector Type
u.FL/IPEX
VSWR (915MHz)
1.704:1
Category
Internal Device Antennas
Gain
<0 dBi
Length
39 mm
Width
15 mm
Test Results
This page collects 1 independent VSWR test of the TE Connectivity / Linx Technologies Linx PCB Flex, measured firsthand by the Mesh community (NB2E). Best measured VSWR is 1.70:1.
Test #1
VSWR Measurements
902MHz
VSWR: 1.752:1
915MHz
VSWR: 1.704:1
928MHz
VSWR: 1.711:1
Notes from test
Antenna flex PCB measures 39x15mm and has a 100mm micro coaxial cable terminated in a u.FL connector. Lowest VSWR during testing was achieved by placing a 5mm x 1.5mm strip of foil tape approximately 3.5cm below, and parallel to, the antenna PCB element. Similar effect could also be produced by using the antenna's adhesive strip to mount the antenna approximately 3.5cm above and parallel to the device PCB to which the antenna connector will be attached.
Tested By
Ric Letson, NB2E (RicInNewMexico) on 15 September 2023